How To Prime A Pool Pump - http://bit.ly/36mZDpf How To Determine Why a Pool Pump Won't Prime - http://bit.ly/30JyqvO How To Clean Out a Pool Pump Impeller - http://bit.ly/37keHFI How to Find Suction Side Air Leaks In A Pool - http://bit.ly/2GhFN4d
SUBSCRIBE for FREE pool care and maintenance videos every week: http://bit.ly/SubscribeINYO ****
VISIT our blog for weekly swimming pool tips, tricks, and more! http://www.inyopools.com/blog SHOP at our online store! http://bit.ly/InyoPools
Listen to the Poolside Chat podcast! iTunes:http://bit.ly/PoolsideChat SoundCloud:https://soundcloud.com/inyopools-com
LIKE us on FACEBOOK! https://www.facebook.com/inyopools FOLLOW us on TWITTER! https://twitter.com/inyopools FOLLOW us on INSTAGRAM! https://www.instagram.com/inyopools/ JOIN our circle on GOOGLE+ https://plus.google.com/+Inyopools/posts
When a system is fully primed, the system components, pipes, pump, filter etc., are filled with water and the pool pump is able to suck water from the pool and push it back into the pool through pool returns. Priming a pool pump involves purging air from the pumping system and filling the water lines and pump with water. The number of steps required to prime your pool pump depends on the amount on water in the suction side of the lines - water coming from the pool to the pump. If you are installing a new pool system, there is no water in the lines, and you may have to repeat these steps several times. If you are adding or replacing components into the pumping system (like a heater), there will still be some water in the lines and priming will be simpler. The following procedure assumes that you have no or little water in the system. Visible indications of low water are no or little water in the pump strainer box, and a low pressure reading on the pool filter pressure gage.
f the pool pump is running, your first step is to turn off the power to the pool pump. For maximum safety turn off the power at the circuit breaker to the motor.
The suction diverter valve allows you to shut off the water from the skimmers or from the main drain. Generally, you cannot shut off both. To prime, the system in steps, move the diverter valve so that the offside of the lever is pointing to the main drain side. Now water can only flow from the pool skimmer lines. Note: if you are only adding a component to an existing system, water will still be in the lines and you can probably re-prime the system by opening the skimmer and main drain lines at the same time (lever is halfway between skimmers and main drains).
Next, you will have to relieve any pressure that remains in the pool pump and water lines. To relieve pressure turn the air relief valve on top of the pool filter counterclockwise. You will hear air releasing as you see the pressure on the pressure gauge go to 0 psi. Leave this relief valve open. READ MORE http://bit.ly/36mZDpf